- Lighting Aim
- Lighting guides
- Bathroom Lighting Zones and IP Ratings Explained
Bathroom Lighting Zones and IP Ratings Explained
Why bathrooms are divided into zones, which IP ratings are commonly required near water and how to light mirrors evenly.
- Guide
- 4 min read

Many wiring regulations divide a bathroom into zones based on distance from water, and require light fittings in each zone to have a minimum IP rating against water. Rules differ by country, so treat the figures here as typical examples and check your local regulations and the fitting's instructions.
Bathrooms combine water and electricity, which is why lighting there is regulated more strictly than in other rooms. At the same time, bathrooms need good light: even light at the mirror for shaving and make-up, and softer light for a relaxing bath. This guide explains zones and IP ratings in general terms and shows how to light the room well. For other rooms, see the home lighting guide.
What an IP rating means
IP stands for ingress protection. It is written as IP followed by two digits. The first digit describes protection against solid objects and dust; the second, protection against water. An X in place of a digit means that aspect was not rated. The scale is explained in more detail in outdoor lighting IP ratings.
Zones: a common example
The UK wiring regulations are often used to explain the idea. They define zones around the bath and shower, and guidance commonly associated with them is:
- Zone 0Inside the bath or shower tray. Fittings must be suitable for immersion (commonly IPX7) and run at extra-low voltage.
- Zone 1Above the bath or shower up to a set height. Commonly at least IPX4; higher where water jets are used.
- Zone 2An area extending around zone 1, including near the basin in some layouts. Commonly at least IPX4.
- Outside the zonesNo specific IP rating is usually required, but a fitting suitable for damp rooms is sensible.
Other countries use different zone definitions and requirements. A qualified electrician will know what applies where you live.
Lighting the mirror
The most useful bathroom light is even light on the face. Lights on both sides of the mirror, or a fitting around it, light the face from the front without shadows under the eyes and chin. A single downlight directly above the mirror tends to cast shadows. Mirror lights must have an IP rating suitable for their position.
Colour temperature and CRI
Neutral to warm-neutral white, roughly 3000–4000 K, with a high CRI helps skin tones and make-up look natural. A warm, dimmable ambient layer makes evening baths more relaxing. See colour temperature explained and CRI explained.
How much light?
Commonly cited ranges for bathrooms are around 150–300 lux, with brighter, focused light at the mirror. A small bathroom does not need many fittings, but they should be placed so the mirror and the shower are well lit. The lux calculator gives a starting point.
Layers in a bathroom
- Ambient: ceiling fittings or downlights with a suitable IP rating.
- Task: even light either side of the mirror.
- Accent: a low-level strip or a niche light for night use and atmosphere.
- Control: separate switches, with pull cords or switches outside the room where regulations require it.
Night lighting
A dim light at floor level or under a vanity lets you use the bathroom at night without switching on bright lights. Motion-sensor fittings work well for this.
Bathroom electrical work is notifiable or regulated in many countries. Always use a qualified electrician, and use only fittings designed and rated for their position.
Frequently asked questions
Can I use any LED strip in a bathroom?
Only strips with an IP rating suitable for their zone and installed as the manufacturer requires.
Do bathroom downlights need to be fire-rated?
That depends on the ceiling construction and local rules; ask your electrician.
Is IP44 enough above a shower?
IP44 is often quoted as a minimum for some zones, but requirements vary; check local regulations.
General information only. Mains wiring, new circuits and work in bathrooms should be carried out by a qualified electrician in line with local regulations. Always follow the product's installation instructions.
01
01